Piston automatic marking process
1: Boot before checking equipment in good condition, adjust the size of the piston ring good size.
2: Open the source of power and gas, so that all pneumatic in the initial value: Feeding in the cylinder to be expected value, rotating cylinder in the horizontal position, the block Liu cylinder and cylinder leak in the location of the drop.
3: At the beginning of material: The piston ring linked to material on the board.
4: Good material, according to switch start-up, when the device will automatically marking the beginning of the following actions.
First, increased cylinder block material, to leak the news release piston cylinder, filled with block after the expected decline in the cylinder.
Second, the rotating cylinder to pick up materials, gas claw closure, expected to take up the cylinder, piston ring to lay down their arms to rotate the cylinder, the cylinder
Leak the news to the decline in situ, the rotating cylinder as the level of decline in value, Open air claw, to lay down their feeding cylinder piston Department.
Third, when sensors detect the test material, feed cylinder marking the beginning of feed.
Fourth, when the piston ring to the marking value, marking the sensor detected signals to the computer, start the marking process, marking the end of the signal feed to the cylinder, the cylinder to continue to feed feed.
Fifth, when the detection switch detects less than expected, the rotating cylinder expected to take up, so to repeat the above actions, automatic feeding systems.
This Machine can work togeather with

The main technical parameters
Piston ring specifications: ¦µ50-¦Õ140
Feed adjustable rate of 0.5-2seconds.
Pressure: 0.4-0.8 Mpa
Control: PLC